|
Post by bigbuck010 on Apr 22, 2009 5:27:49 GMT -5
I dropped a valve friday night , when I torn the motor down to be repaired . I noticed all the rod bearings where down to the brass. This motor was new 3 laps .
BUT I had 40 psi oil pressure at idle and all the main bearings looked fine .
any suggestions what could be the problem here , I checked all clearances and had 2 thousands oil clearances when I assembled it ? Thanks Dan
|
|
|
Post by troyk3 on Apr 22, 2009 13:32:12 GMT -5
Did you get everything balanced ( Crank, Rods Pistons )
|
|
|
Post by bigbuck010 on Apr 22, 2009 16:59:54 GMT -5
yes it was done , I found out maybe i did nt seal the thrust bearing cap correctly ?
|
|